Owner Manual

19
MODEL RT2000 (X2) INSTALLATION GUIDE
10. 
Control panel slots.

Mount fascia trim to control panel.
*** WARNING ***
When removing/placing the unit on the plinth, be
mindful that the unit is top-heavy. One person should
support the front at all times! Take care not to damage
the front of the sleeve as this has the control panel
electronics and hardware mounted.
11. Adjust the plinth’s
the cabinet is level.
12 
tape, pencil, etc. Remove the control panel trim and slide the unit back inside.
13. Remove the unit from the plinth (if used). Align the plinth over the markings and mark the anchor holes.

used) and again slide the unit forward towards the wall opening until the sleeve protrudes slightly out
the front exterior.
If no plinth was used, after drilling the anchor holes, again slide the unit forward towards the wall
opening until the sleeve protrudes slightly out the front exterior.
The next pages describes adjusting the optional plinth and leveling feet of cabinet.