Owner Manual

ManualsBrandsTriton Systems ManualsOtherRT2000 Series

X2 MAIN BOARD REPLACEMENT

(MODEM / PRINTER VERIFICATION)

TDN 07103-00176 03/2008

CORPORATE HEADQUARTERS:

522 E. Railroad Street

Long Beach, MS 39560

Phone: (228) 868-1317

Fax: (228) 868-0437

RMA (RETURN MATERIAL AUTHORIZATION)

RETURN ADDRESS:

21405 Avenue “B”

Long Beach, MS 39560

Inc. is an operating company of Dover Electronics, Inc., a subsidiary of Dover Corporation

(NYSE-DOV). DOVER, the DOVER logo and the Dover family of marks and TRITON, the

TRITON logo and the Triton family of marks are registered trademarks of Delaware Capital

Formation, Inc., a wholly owned subsidiary of Dover Corporation.

Summary of content (5 pages)

PAGE 1
X2 MAIN BOARD REPLACEMENT (MODEM / PRINTER VERIFICATION) TDN 07103-00176 03/2008 CORPORATE HEADQUARTERS: 522 E. Railroad Street Long Beach, MS 39560 Phone: (228) 868-1317 Fax: (228) 868-0437 RMA (RETURN MATERIAL AUTHORIZATION) RETURN ADDRESS: 21405 Avenue “B” Long Beach, MS 39560 COPYRIGHT NOTICE © 2007 Delaware Capital Formation, Inc. All Rights Reserved. Triton Systems of Delaware, Inc. is an operating company of Dover Electronics, Inc., a subsidiary of Dover Corporation (NYSE-DOV).
PAGE 2
X2 MAIN BOARD REPLACEMENT (MODEM/PRINTER VERIFICATION) LOADING THE X2 MULTITECH MODEM CONFIGURATION FILE (REQUIRED FOR X2 MAIN BOARD REPLACEMENT THAT EMPLOYS THE MULTITECH USB MODEM) You will need a Flash drive device (USB storage device shown) with the “X2MultitechModemCfg.tfv” configuration file loaded in it (CD included with Main board replacement has software file included). * NOTE * To update software for Models FT5000 and RT2000, access Management Functions from the front display (customer side).
PAGE 3
X2 MAIN BOARD REPLACEMENT (MODEM/PRINTER VERIFICATION) 5. 6. When the “LOOK IN” option has “USB” present, the “F ILES OF T YPE ” screen should have the Multitech load file software, size, and date/time attributes (and any other file loaded in the Flash drive. See NOTE, right. * NOTE * X2 TERMINAL SOFTWARE IS IDENTIFIED WITH A .TFV EXTENSION. Use the left and right keys on the keypad to highlight/select the following file: X2MultitechModemCfg.tfv 7.
PAGE 4
X2 MAIN BOARD REPLACEMENT (MODEM/PRINTER VERIFICATION) VERIFYING THE PRINTER PRESENTER 1. Enter MANAGEMENT FUNCTIONS > MAIN MENU screen. Select DIAGNOSTICS option <2> , then PRINTER option <6>. 2. Press <1>, DEVICE STATUS. A Management report is displayed. 3. Scroll down to the “Presenter Installed” and “Presenter Stored” line items. If there is a difference in the status report between either (ex: “Presenter Installed”: Yes, “Presenter Stored”: No), proceed to the next step.
PAGE 5
X2 MAIN BOARD REPLACEMENT (MODEM/PRINTER VERIFICATION) 4. Press <3>, CONFIGURE PRINTER. Press the key to scroll down/highlight the “Reset All” option. Press the key. Printer w/presenter 5. Perform another DEVICE STATUS to verify “Presenter Installed” and “Presenter Stored” status are the same. Also verify if the “Device Status” line item reflects: 0 (Device Ready). Note: Recommend perform a RESET\TEST PRINTER function