Owner Manual

8
T5 PCI-EPP ConvErsIon ProCEdUrEs
3. rEMovE THE vEPP sPEd assEMBly and InsTall THE T5 PCI-EPP. sECUrE wITH THE sIx (6) sCrEws InClUdEd In kIT (k40x20,
PT FasTEnEr sCrEw). noTE: IF THErE was a groUnd wIrE aTTaCHEd To THE FT sPEd, rEaTTaCH and sECUrE.
4. TraCE THE Two FUnCTIon kEy CaBlEs and dIsConnECT/rEMovE FroM THE UnIT. THEsE wIll BE rEPlaCEd By THE nEw CoMBInEd
FUnCTIon kEy CaBlE InClUdEd In kIT.
5. ConnECT THE nEw FUnCTIon kEy CaBlE Ends To THE rEsPECTIvE kEyPad PCBs. THE CaBlE Ends arE MarkEd “leFT” and
“righT”. ProPErly drEss and roUTE THE IndIvIdUal lEFT and rIgHT FUnCTIon kEy CaBlEs To THE T5 PCI-EPP.
Gnd wire connection
Left
Right
Right
Left
rEMEMBEr: CaBlE dEsIgnaTIons For THE FUnCTIon kEys arE rEFErEnCEd wHEn vIEwIng UnIT FroM THE FronT.
rEFErEnCE PlaCEMEnT oF ConnECTors wHEn vIEwIng UnITs wITH ConTrol PanEl down (rl5000) and rEar CaBInET oPEnEd
(FT5000). vIEw FIgUrEs aBovE.
** IMPORTANT **
The K40x20 PT Fastener (included in the kit) should always be used to secure PCI-EPP’s with
ground wire connections!
Model RL5000
Model FT5000
Model RL5000
Model FT5000