Owner Manual

7
T5 PCI-EPP ConvErsIon ProCEdUrEs
NOTE: Before proceeding with the hardware upgrade procedures, terminal power MUST be removed. Enter ManageMenT
FuncTions > sysTeM ParaMeTers > shuT Down The TerMinal. When prompted “It is now safe to turn off your computer”on the
screen, open the control panel/rear cabinet door and turn the power switch on the power supply to the <OFF> (0) position.
rl5000 / FT5000 uniTs:
1. dIsConnECT THE THrEE (3) CaBlEs FroM THE vEPP sPEd assEMBly (2 FUnCTIon kEy, 1 daTa CaBlE sHown BElow).
Model RL5000
Model FT5000
2. rEMovE THE sIx (6) sCrEws sHown THaT sECUrE THE sPEd assEMBly (THEsE sCrEws wIll BE rEPlaCEd).