Owner Manual

15
T5 PCI-EPP ConvErsIon ProCEdUrEs
lIFTIng THE dIsPlay assEMBly agaIn, ConnECT THE nEw FUnCTIon kEy CaBlE Ends To THEIr rEsPECTIvE kEyPad PCBs. THE
CaBlE Ends arE MarkEd “leFT” and “righT”. roUTE sPlIT CaBlE Ends THroUgH THE CaBlE gUIdEs PrEvIoUsly UsEd For
rEPlaCEd CaBlEs.
rEMEMBEr: CaBlE dEsIgnaTIons For THE FUnCTIon kEys arE rEFErEnCEd wHEn vIEwIng UnIT FroM THE FronT.
rEFErEnCE PlaCEMEnT oF ConnECTors wHEn vIEwIng UnIT wITH ConTrol PanEl down (rl2000). vIEw FIgUrE BElow.
sECUrE THE dIsPlay assEMBly To THE ConTrol PanEl wITH THE FoUr (4) sCrEws PrEvIoUsly rEMovEd.
rEInsTall THE x2 MaIn Board assEMBly.
Ty wrap
T5 PCI-EPP installed in the RL 2000
PlUg THE CoMBInEd, sInglE ConnECTor For THE FUnCTIon kEys (InClUdIng THE HEaTEr PowEr CaBlE IF a METal T5 PCI-
EPP w/HEaTEr Is BEIng InsTallEd) InTo THE T5 PCI-EPP. rEConnECT THE sPEd daTa CaBlE PrEvIoUsly rEMovEd (rj-45
ConnECTor End). PrEss THE nEw FUnCTIon kEy CaBlEs (InClUdIng THE HEaTEr PowEr CaBlE IF a METal T5 PCI-EPP w/
HEaTEr Is BEIng InsTallEd) BaCk InTo THE FlEx TUBE and Ty wraP all CaBlEs as sHown.
METAL T5 PCI-EPP W/HEATER CONVERSIONS ONLY! Properly dress and route THE IndIvIdUal 12vdC HEaTEr CaBlE
To THE PowEr sUPPly and PlUg IT InTo any avaIlaBlE 8 PIn ConnECTor.
12vdc heater cable
to power supply
Metal T5 PCI-EPP heater cable routed to
the RL2000 power supply (via cable track or
guides)
rEMEMBEr: THE FUnCTIon kEy CaBlE For THE METal T5 PCI-EPP w/HEaTEr Has an addITIonal Two (2) wIrEs (rEd
and BlaCk) For THE InTErnal HEaTEr. THE IndIvIdUal CaBlE THaT sUPPlIEs 12vdC To THE HEaTEr sHoUld BE ProPErly drEssEs
and roUTEd To THE PowEr sUPPly and PlUggEd InTo any 8-PIn ConnECTors. vIEw FIgUrEs aBovE.
Metal T5 PCI-EPP W/Heater installed in the RL2000
Function
Keys
12vdc heater cable
to power supply
Cable
Routing
To Right
Functional Keypad
To Left Functional Keypad