Owner Manual

33
3. Use a 15 mm (9/16”) diameter
carbide-tipped masonry bit to
drill four holes at least 115 mm (4
1/2”) deep into the oor. Be sure
to take into account the depth of
any oor covering, such as tile or
vinyl when gauging the depth of
the anchor holes. Make sure the
holes are drilled at least 115 mm
(4 1/2”) into the concrete oor.
4. Use a blower or portable vacuum
cleaner to remove any dust or
debris that may have fallen into
the holes during the drilling
process. Brush the hole with
the wire brush to loosen any
additional debris, then blow or
vacuum again. Holes may be
dry or damp, but must be free of
standing water or frost!
Fig. 2. Blow out dust/debris.
Fig. 3. Remove dust with wire brush.
CabINET INsTaLLaTION - CHEMICaL aNCHORs