Owner Manual

13
8. Power Supply/Cables - Open the control panel. Connect the EJ to Docking
board cable (RJ-45 connector end) to the “Dispenser” port of Docking board.
Route the cable through the cable guides (see Figure 4, “Disassembly
Procedures”). Next, install the new power supply by reversing the procedures
in Step 1, “Disassembly Procedures”. Reconnect all power cables (AC/
DC) to the power supply (Figure 17). Reconnect ATM power cord to wall
outlet, if applicable.
Figure 17. Power supply connected.
The following illustrations show the installation of the slide catch bracket to the
dispenser slide rail. Tool required is a #2 flat-tip screwdriver. Installation time
approximately less than 5 minutes. See table below to determine which type and
placement for the catch bracket.
03011-
02032
(L-bracket)
03011-
02033
(Acute-angle
Step 1
Fully extend mechanism. Remove screw shown from Right
or Left side rail (see table). Retain screw.
Step 2
Slide catch bracket through slot on front of rail (L-shaped or
angle end pointing out).
Step 3
Secure bracket with screw previously removed.
Step 4
Slide mechanism back in cabinet.
)tnemecalP/ledoM(potSedilS05-DMN
tenibaC/ledoM #tekcarB tnemecalP
5115LR
)eldnaH-tfiL/sruoHssenisuB(
33020-11030edisthgiR
5215LR
)tluaV-1leveL(
33020-11030edistfeL
Angle