Owner Manual

5
FOR UNITS WITH 03011-01810 BRACKET
The Modem is located in the control panel.
Tools:
1 - ESD wrist strap with grounding cord.
To remove the modem assembly complete the following procedure:
1. Put the ESD wrist strap on and attach the cord to ground.
2. Perform a proper shutdown of the unit. Unlock and open the upper portion of the cabinet.
3. Push the AC power ON/OFF switch on the power supply to the OFF (0) position.
4. Remove the current modem from the unit. Remove all modem cables EXCEPT for the phone cable.
5. Install the Serial Modem by lining up the notches on the back of the modem with the posts on the modem
bracket. Slide the modem onto the bracket posts until it clicks into place. Ensure the Power and Serial
Ports are facing towards the docking board.
6. Plug the phone cable into the modem “Line In” port.