Owner Manual

13
SECTION 2 - CONVERSION WITH “CURRENT” STYLE CABINETS (W/LIFT HANDLE)
4. Dispenser/Cabinet Grounds - Reconnect the cabinet ground wire removed in
Step 7 (page 11) to the front left screw. Install the dispenser ground wire
included and secure both ground wires with the nut previously removed (Figure
9). The other end of dispenser ground wire will attach to the NMD-50 when
installed.
Figure 9. Ground wires installed.
5. Dispenser Power and Data Cables - Feed the EJ to Docking board cable (RJ-
45 connector end) through the control panel access hole. Feed the dispenser
power cable (insert) also up to the control panel (Figure 10). These 2 cables
will be connected in later steps. Route the 2 cables in the vault area (EJ to
dispenser, dispenser power cable end) in the existing cabinet cable clips (Figure
11).
Dispenser power cable
Figure 12. EJ and dispenser power cables.
Figure 11. Route power/data cables.
6. Dispenser - Extend the slides fully. Ensure all cables in vault area have been moved out of way before installing
mechanism. Remove cardboard support from mechanism cassettes. With 2-personnel, lift the NMD-50 by the green
handles and align the rails on the dispenser with the slide rails. Insert the rails and slide mechanism up to the rail stops
(Figure 12). Push the release tabs in (Figure 13) and continue sliding mechanism fully into cabinet. Repeat extending/
inserting mechanism into cabinet a few times to ensure no binding on slide rails.
Figure 12. Insert mechanism to rail stop.
Figure 13. Push release tab.
7. Dispenser Cables - Connect the power, data, and ground wires to the NMD-50 as shown in Figures 14 and 15. Route
the cables through the cable clips attached to the mechanism covers (Figure 16). Ground wire routes down behind
slide and through the lower cable clips. Note: Ensure ground wire doesn’t catch on cabinet shoulder bolts when
sliding mechanism into cabinet.
Ground wire routing
Release tab
Figure 15. Data/ground connections.
Figure 14. Power cable connection.
Figure 16. Route cables thru clips.