Owner Manual

TDL GaTeway MoDeM
4
NOTE: This second proper restart is required to marry the SSL certicate to the ATM.
Failure to perform this second restart may cause the SSL certicate to be lost if an improper
shut down occurs.
SSL Certicate Load Files (if more than 1 are listed, install both load les):
SSL les are required to allow the ATM to communicate with your host/processor
more securely. Some les are loaded in the updates you just performed. Use the
chart below to determine the additional les required for your ATM.
•Go to Management > System Parameters > Software Update and select load le(s)
from table below to enable SSL for the specied processor, if this has not been installed
previously.
• System will restart and install software.
•After system restarts, go to Management > System Parameters > Restart Terminal again.
Service Packs to load
• xu20xcmn2.4.0sp4a.tlf - X1 (XScale) US Update (must install on US 2.4.0)
Inside web site zip le: XScale_2.4.0_TDL Gateway Modem.exe
• xu30xcmn2.4.0sp4a.tfv - X2 US Update (must install on US 2.4.0)
Inside web site zip le: X2_2.4.0_TDL Gateway Modem.exe
• xu30xcmn3.0.0sp3.tfv - Traverse US Update (must install on US 3.0.0)
Inside web site zip le: X2_3.0.0_TDL Gateway Modem.exe