Owner Manual
insTaLLaTion
3
Software Installation:
• Check Management > Terminal Status > Conguration Summary > Program
Version.
• If “Program Version” is earlier than 2.4.0, the application will need to be
upgraded using the following instructions, must be completed before proceeding:
1. With USB ash drive inserted, go to Management > Terminal Status > Save
Parameters To External Storage. Press ENTER to continue.
2. Go to Management > System Parameters > Software Update and select load le:
3. System will restart and install software.
4. For XScale only, or any full load (xd), also do the following:
After system boots, login to Management Functions and select “us.tsf” when
prompted for country option. Press ENTER to accept verication screen.
Select “Restore Parameters from External Storage” and select le saved in step 1.
Press ENTER to accept verication screen.
Review optional screen and optional screen button settings in Management >
Terminal Status > Conguration Summary to conrm everything is correct.
Software to Update to 2.4.0 (if Unit is already 2.4.0 proceed to the service packs)
• xd20xcsf2.4.0.tlf - X1 (XScale)
Inside web site le: 2_4_0 US XScale 10_4 color.exe
• xu30xcsf2.4.0.tfv - (X2 8” or 10.4” display)
Inside web site le: 2_4_0 US X2 8 and 10.4.exe
• xu30dcsf2.4.0.tfv - (X2 5.7” display)
Inside web site le: 2_4_0 US X2 5_7.exe
• Traverse - No update required
DO NOT PLUG IN THE MODEM AND START THE ATM UNTIL
ALL SOFTWARE HAS BEEN INSTALLED!
ATM must be at a minimum 2.4.0 with service packs and SSL certicates loaded
Service Pack Installation:
Repeat steps 2 & 3 to load the applicable Service Pack. Service Packs are required.