Owner Manual

ADVANCED SECURITY MODULE UPGRADE PROCEDURES

TRAVERSE UPGRADE

BEFORE PROCEEDING:

• Ensure all of your Journal Records have been saved to a USB ﬂ ash drive.

• Perform a proper management function shut down to remove power from the ATM.

• Unlock and open the ATM control panel. Turn the power switch to the OFF (0) position. If possible,

unplug the ATM power cord at the wall outlet.

• Open the dispenser area.

Installation

1. Obtain the security module and bracket. Insert the two posts on the bracket into the two notches on

the security module.

2. Gently push the security module towards the two

posts, ﬂ exing the plastic ends slightly on both

sides, to insert the single post on the bracket into

the single notch on the module.

3. Connect the SM to CDU Communication cable

to the security module. Secure the cable to the

security module by tightening the screws with

a small ﬂ athead screwdriver.