Owner Manual

ManualsBrandsTriton Systems ManualsOtherRL2000 Series

RL2000 & RL5000

AC PoweR CoRd

BRACket

InstALLAtIon

TDN 07103-00199 April 21, 2010

registered trademark of Triton Systems of Delaware, LLC

CoRPoRAte HeAdquARteRs:

21405 B Street

Long Beach, MS 39560

Phone: (228) 575-3188

Fax: (228) 575-3200

Summary of content (4 pages)

PAGE 1
RL2000 & RL5000 AC Power Cord Bracket Installation TDN 07103-00199 April 21, 2010 Corporate Headquarters: 21405 B Street Long Beach, MS 39560 Phone: (228) 575-3188 Fax: (228) 575-3200 COPYRIGHT NOTICE © 2010 Triton. All Rights Reserved.
PAGE 2
RL2000 & RL5000 Document Updates April 21, 2010 Original Table of Contents Introduction Section 1 Purpose, Scope, Application, Parts & Tools...............................................pg 2 AC Power Cord Bracket Installation .........................................................pg 3 Purpose This guide covers the steps for installing a support bracket for the AC power cord in the applicable ATMs.
PAGE 3
AC Power Cord Bracket Installation Section 1 Installation Procedure - Follow the appropriate procedure to shut down your particular ATM and remove power. RL 2000 with NMD example - Remove your particular dispenser type. Disconnect cables and set it aside. - Remove the dispenser tray from the slides. - Loosely attach the power cable to the bracket with the ty wraps provided. Inspect the power cord for chaffing and repair as necessary. - Remove the mounting screws from the rear of left side slide assembly.
PAGE 4
RL2000 & RL5000 RL 5000 with SDD example - If using this style of bracket, the left side slide assembly must be removed. - The bracket is then installed and secured loosely. Inspect the power cord for chaffing and repair as necessary. - The slide assembly is then slid behind the bracket, and then secured. - Pull the ty wraps snug to secure the power cord. - Cut off any excess as necessary. All Units Reinstall the tray and dispenser.