Owner Manual
7
NMD to SDD CoNverSioN
At left: NMD unit in RL
5000 before conversion to
SDD. At right: RL 5000
cabinet converted to in-
corporate SDD dispenser.
Conversion will change dis-
pensing system from a dual
cassette unit to a single dis-
penser. Mounting methods
vary, depending on cabinet
model. Cabinet model can
be identied by sticker lo-
cated on inside right or left
of cabinet.
2. Open door fully. Secure top and bottom bill tray pieces
to inside of cabinet door with four (4) nuts and washers,
(see gure 5). Trays t together at notches in edges then
mount to inner door.
3. To secure deck, lower deck plate onto pins located on
either side of inner cabinet. Secure with hex nuts.
4. With deck secure, rest SDD unit on top, but do not
secure dispenser to deck at this time.
5. Secure all wiring to rear of dispenser unit. Locate con-
nections for power cable, communications cable and data
cable and connect rmly to unit in specied locations at
rear of SDD.
6. Check all other cable connections to make sure they are
snug and tight.
7. Slide dispenser toward rear of deck and allow base to
slip beneath anges on rear of deck. Lower front of SDD
down onto threaded studs at front of deck. Secure SDD
with two (2) wing nuts.
8. Load cassette with bills and place in dispenser.
9. Return power to unit and test functionality.
RL 5000
RL 5000 units convert to a
xed deck that supports SDD.
Locate model number on in-
ner wall of cabinet.