Owner Manual

6
NMD to SDD CoNverSioN
TOOLS REQUIRED
#2 Phillips screwdriver or hex driver
KIT 06200-00232
Cabinet 09700-00000 - NMD to SDD Conversion Kit
required parts aNd tools
sdd iNstallatioN (seCtioN 3)
1. Before installation, make sure all wiring is clear and out of way of sliding rails, doors and
other moveable parts. Keep wiring and harnesses in rear area of cabinet during conversion.
This section contains information necessary for the installation of the stationary SDD single dispenser unit
on RL 5000 ATM units. Installation instructions vary, depending on cabinet conguration. Determine the
section necessary to conform to a specic unit and conguration. Not all sections apply to all units. To
determine cabinet model number, locate sticker on inside left or right panel of cabinet.
converting caBinet 09700-00000 (rL 5000)
Items in kit Description Qty
03011-00842
Bill Tray, Top
03011-00382
Bill Tray, Bottom
03011-01591
Dispenser Tray, SDD ROHS
09600-00027
Cable|EJ to SDD ROHS
03082-00027
Mech-00, 18-inch Slides ROHS
09120-07011
Cable|DC Power|SDD ROHS
Figure 6
Secure front of unit to deck with wing nuts on studs
on both sides of cabinet.
Figure 7
Underside of dispenser deck attaches to slide
rails on both sides at points shown
5. Before securing SDD to deck, rest unit on deck and attach power cable, communica-
tion cable and data cable to appropriate connections at rear of unit. Make sure all wiring
is clear of deck and in rear of cabinet before mounting SDD to deck. Attach deck to slides
on both sides using six (6) hex nuts provided, (see gure 7).
6. Slide rear of SDD into ange at rear of deck. Lower front of SDD onto two threaded
studs and secure with wing nuts, (see gure 6).