Owner Manual

5
NMD to SDD CoNverSioN
sdd iNstallatioN (seCtioN 2)
1. Before installation, make sure all wiring is clear and out of the way of sliding rails, doors and
any other moveable parts. Keep wiring and harnesses in rear area of cabinet during conversion
and try not to place tension on cabling.
2. Attach top and bottom bill trays to door of unit using four nuts and washers, (see gure 5).
Trays t together at notches in edges then mount to inner door.
TOOLS REQUIRED
#2 Phillips screwdriver or hex driver
KIT 06200-00233
Cabinets 03015-00052 and 03015-00167- NMD to SDD Conversion Kit
required parts aNd tools
This section contains information necessary for the installation of the SDD single dispenser unit on RL 5000
ATMs. Installation instructions vary, depending on cabinet conguration. Determine the section necessary
to conform to a specic unit and conguration. Not all sections apply to all units.
converting caBinetS 03015-00052/03015-00167
(rL 5000)
Items in kit Description Qty
03011-00658
Bracket, Slide Mount, Left ROHS 1
03011-01604
Bracket, Slide Mount, Right ROHS 1
03011-00614
Bill Tray, Top ROHS 1
03011-00615
Bill Tray, Bottom ROHS 1
09120-07017
SDD Data Cable ROHS 1
03072-00038
Cable Clip|3/4” Round, Screw-In|Quick Release| ROHS 1
02054-00201
Screw|#8-32|5/8 Inch|||Truss Phillips Head|| 16
09120-00311
Cable|Communications|Main Board to EJ ROHS 1
09600-00027
Cable|EJ to SDD ROHS 1
03011-01591
Dispenser Tray, SDD ROHS 1
03082-00027
Mech-00, 18 Inches Slides ROHS 2
09120-07011
Cable|DC Power|SDD ROHS 1
Figure 5
Attach bill tray inside door of cabinet
3. Open cabinet door fully and attach left and right slide
mounts to inner wall of cabinet using #8 Phillips head
screws supplied in kit.
4. Secure deck and slide rails to side mounts with Phillips
screws. Attach rear rst, then slide rails into unit until
oblong holes in slides align with holes in mounts. Secure
front of slide rails.