Owner Manual

NMD to SDD CoNverSioN

sdd iNstallatioN (seCtioN 1)

1. Before installation, ensure all wiring is clear of sliding rails, doors

and moveable parts. Keep wiring and harnesses in rear area of cabinet

during conversion.

2. After NMD removal, attach stationary deck to inside of cabinet by

sliding slots in deck down onto six (6) threaded pins on cabinet sides.

Secure deck to inner cabinet with six (6) nuts provided in kit.

3. Before attaching dispenser to deck, place unit on top of deck and

secure all wiring to rear of unit. Attach data, power and communication

cables to control board and use clips provided in kit to secure wiring.

Check all other wiring to make sure connections are snug and wiring

is clear of moveable parts.

4. The SDD attaches to stationary tray by sliding lower plate of unit

into slot at rear of deck. Lower unit down onto two studs at front of

deck and tighten with two wing nuts to secure unit. Make sure wiring

is clear of underside of deck before attaching.

5. Once mechanism is secure on deck and inside cabinet, load cassette

and currency, restore power to unit and test functionality.

This section contains information necessary for the installation of the SDD single dispenser unit on RL

2000 ATMs. Installation instructions vary, depending on cabinet conguration. Determine the section

necessary to conform to a specic unit and conguration. Not all sections apply to all units. To determine

cabinet model number, locate sticker on inside left panel of cabinet.

required parts aNd tools

RL 2000

The RL 2000 uses a sta-

tionary dispenser deck to

support SDD unit.

TOOLS REQUIRED

#2 Phillips screwdriver or hex driver

KIT 06200-00234

Cabinet 03015-00253- NMD to SDD Conversion Kit

converting caBinet 03015-00253 (rL 2000)

Items in kit Description Qty

02301-00024

Nut|#8-32|Hex Nut|Ext. Tooth Washer ROHS 6

03011-01552

Stationary Tray, SDD ROHS 1

02301-00026

Nut|1/4-20|||Wing Nut ROHS 2

09120-07017

SDD Data Cable ROHS 1

03072-00038

Cable Clip|3/4” Round, Screw-In|Quick Release| ROHS 1

09120-07011

Cable|DC Power|SDD ROHS 1