Owner Manual

3 -23
RL5000 NMD50
8. Install 6 bolts into one closeout bracket. Set
the closeout bracket in place in the right
opening. Install 6 bolts in the second closeout
bracket. Set the second closeout bracket in
the read left opening. Ensure the bolts and
brackets are sitting fl at on the upper cabinet.
9. Ensure the bolts are not intertwined in the
cables in the lower cabinet. Remove the cable
clip from the rear left of the lower cabinet.
10. Install the lower closeout bracket on the bolts
in the lower cabinet. Using the 7/16” hollow
shaft nut driver, install the 6 hex nuts on the
bolts. While tightening, ensure the bolts and
bracket are sitting fl at in the upper cabinet.