Owner Manual

3-22
HOLE CLOSEOUT BRACKET KIT
Vault # 03015-00064 / 03015-00200 / 03015-00227 with an NMD 50 Dispenser
**If the unit has been upgraded, skip to step #8.
5. From the upper portion of the cabinet, remove
the two bolts & two washers that secure
the anti-phishing bracket. Set aside for
reinstallation.
6. Route the security module power cable and
security module communications cable through
the rear upper middle cable clip on the top of
the vault. Continue routing the cables past the
back opening (green circle) and through the
upper left cable clip. Route the cables into the
upper portion of the cabinet through the left hole
opening and the anti-phishing bracket.
7. Obtain the dispenser power cable. Plug the
power cable into the unit’s power supply in the
upper portion of the cabinet. Route the cable
through the anti-phishing bracket and the left
hole opening into the lower cabinet.
Reinstall the two washers and two bolts to secure
the anti-phishing bracket.