Owner Manual

3-12
HOLE CLOSEOUT BRACKET KIT
13. With the dispenser still removed from the
unit, peel the paper backing off one Panduit
Adhesive Cable Clip and adhere it to the back
right side of the NMD50 dispenser. Peel the
paper backing off another Panduit Adhesive
Cable Clip and adhere it to the front right side
of the NMD50 dispenser. Note the orientation
of the clips in the pictures.
11. Reinstall the cable clip over the closeout
bracket as shown.
12. Install the second lower closeout bracket on
the bolts in the lower cabinet. Using the 7/16”
hollow shaft nut driver, install the 6 hex nuts
on the bolts. While tightening, ensure the bolts
and bracket are sitting fl at in the upper cabinet.
(picture shown with all clips and additional
hardware removed from cabinet for clarity)