Owner Manual

3-8
HOLE CLOSEOUT BRACKET KIT
14. Plug the Dispenser Power Cable into the side
of the NMD50 as shown.
15. Tuck the ground wire under the clip on the
side of the dispenser. Route the power cable
through the two cable clips along the left side
of the dispenser. Route the cable around to the
rear of the dispenser and through the cable clip
on the back left side of the NMD50.
16. Route the Dispenser data cable from the
security module assembly through the two
cable clips on the right side of the NMD50
dispenser as shown.
(Dispenser removed from the unit for clarifi cation)