Owner Manual

3 -5
RL5000 NMD50
6. Obtain the dispenser power cable. Plug the
power cable into the unit’s power supply in the
upper portion of the cabinet. Route the cable
through the left hole opening into the lower
cabinet.
5. Route the security module power cable and the
security module communication cable through
the upper back middle cable clip and the upper
left front cable clip as shown. Route the excess
power and communication cable into the upper
cabinet through the left hole opening.
Cabinet # 09700-00000 with an NMD 50 Dispenser
**If the unit has been upgraded, skip to step #7.
7. Install the 6 bolts into one closeout bracket.
Set the closeout bracket in place into the
right opening as shown. Ensure the bolts and
bracket are sitting fl at on the upper cabinet.