Owner Manual

2-21

RL5000 SDD

9. Install the lower closeout bracket on the 6 bolts

on the right opening. Using the 7/16” hollow

shaft but driver, install 6 hex nuts on the bolts.

Install the second closeout bracket onto the

4 bolts on the middle opening. Install 4 hex

nuts on the bolts. While tightening, ensure the

bolts and brackets are sitting ﬂ at in the upper

cabinet.

8. Install 6 bolts into one closeout bracket. Set

the bracket in place into the right opening.

Install 4 bolts, into the middle holes of the

closeout bracket, and set it in place in the

middle opening as shown. Ensure the bolts and

brackets are sitting ﬂ at on the upper cabinet.

10. Plug the cables into the back of the SDD

dispenser and tighten the thumbscrews on the

communication cable to secure it. Reinstall

the dispenser into the unit.