Owner Manual

2-17
RL5000 SDD
8. Loop the SDD dispenser communication cable
back on itself twice to condense the length of
the cable to match the length of the dispenser
power cable. TY Wrap the two cables together
in two spots as shown. Cut off the excess TY
Wraps.
9. Install 6 bolts into one closeout bracket. Set
the closeout bracket in place in the right
opening. Install 6 bolts in the second closeout
bracket. Set the second closeout bracket in
the read left opening. Ensure the bolts and
brackets are sitting fl at on the upper cabinet.
10. Ensure the bolts are not intertwined in the
cables in the lower cabinet. Remove the cable
clip from the rear left of the lower cabinet.