Owner Manual

2-16
HOLE CLOSEOUT BRACKET KIT
6. Route the security module power cable and
security module communications cable
through the upper middle back two clips.
Route the cables into the upper portion of the
cabinet through the left front hole opening and
the anti-phishing bracket as shown.
5. From the upper portion of the cabinet, remove
the two bolts & washers securing the anti-
phishing bracket. Set aside for reinstallation.
7. Obtain the dispenser power cable. Plug the
power cable into the unit’s power supply in
the upper portion of the cabinet. Route the
cable through the anti-fi shing bracket and the
left hole opening into the vault. Route the
dispenser power cable through the rear left
cable clip as shown.
Reinstall the two washers and two bolts to secure
the anti-phishing bracket.
Vault # 03015-00064 / 03015-00200 / 03015-00227 with an SDD Dispenser
**If the unit has been upgraded with a security module, skip to step #9.