Owner Manual

2-10
HOLE CLOSEOUT BRACKET KIT
11. Install the lower close out bracket on the bolts.
Using the 7/16” hollow shaft nut driver, install
6 hex nuts on the bolts. While tightening,
ensure the bolts and bracket are sitting fl at in
the upper cabinet.
12. Reinstall the cable clip over the closeout
bracket as shown.
13. Install the second lower closeout bracket on
the bolts in the lower cabinet. Using the 7/16”
hollow shaft nut driver, install the 6 hex nuts
on the bolts. While tightening, ensure the bolts
and bracket are sitting fl at in the upper cabinet.
(picture shown with all clips and additional
hardware removed from cabinet for clarity)