Owner Manual

2-5
RL5000 SDD
Cabinet # 09700-00000 with an SDD Dispenser
**If the unit has been upgraded to security module, skip to step #8.
6. Obtain the dispenser power cable. Plug the
power cable into the unit’s power supply in the
upper portion of the cabinet. Route the cable
through the left hole opening into the lower
cabinet. Route the cable through the two left
side cable clips.
5. Feed the security module power cable and
communication cable down through the left
opening into the lower cabinet. Route the
cables through the upper left front and upper
back middle cable clips as shown. Plug the
cables into the security module.
7. Loop the SDD dispenser communication cable
back on itself twice to condense the length of
the cable to match the length of the dispenser
power cable. TY Wrap the two cables together
in two spots as shown. Cut off the excess TY
Wraps.