Owner Manual

2
NMD HaNDle CoNversioN
CoNteNts
PerForMiNg tHe NMD HaNDle CoNversioN
iNtroDuCtioN
This guide covers the steps for installing the newer style handles onto your current NMD50 tted with the
older style handles. This allows a more exible utilization of your NMD50 dispensers.
sCoPe
The following procedures apply to all Triton certied service personnel involved in the process of maintaining
or converting Triton ATMs. This conversion is applicable to NMD50s in the following units; RL2300 & RL5300
cabinets and vaults. For the RL5300, the date code is on or after 09314.
overview
The NMD50 handle conversion kit will replace the existing handles and slides onto your current NMD50 as-
sembly with a new handle, allowing its use in newer style cabinets. The kit includes the handles and associated
mounting hardware.
IntroductIon........................................................................................................................................2
Scope...............................................................................................................................................................2
overvIew.........................................................................................................................................................2
requIred partS and toolS.............................................................................................................................3
remove and replace HandleS........................................................................................................................3
Document Updates
March 27, 2012 Original
CorreCt t20 Driver tiP
iNCorreCt t20 Driver tiP
Note oN requireD Driver
Note the tips on the two Torx Drivers at right. While
they are both T20 drivers, only the lengthier driver
tip will correctly manage the mounting screws that
secure the handle due to the depth of the screw head.
The shorter driver tip will not t deep enough into the
screw head to adjust it.