Owner Manual

ManualsBrandsTriton Systems ManualsOtherNMD

NMD50 HaNDle CoNversioN

FielD iNstallatioN ProCeDure

tDN 07103-00218 MarCH 27, 2012

registered trademark of Triton Systems of Delaware, LLC

21405 B Street

Long Beach, MS 39560

Phone: (800) 259-6672

Fax: (228) 868-9445

CorPorate HeaDquarters:

Summary of content (4 pages)

PAGE 1
NMD50 Handle Conversion Field Installation Procedure TDN 07103-00218 March 27, 2012 Corporate Headquarters: 21405 B Street Long Beach, MS 39560 Phone: (800) 259-6672 Fax: (228) 868-9445 COPYRIGHT NOTICE © 2012 Triton. All Rights Reserved.
PAGE 2
NMD Handle Conversion Document Updates March 27, 2012 Original Contents Performing the NMD Handle Conversion Introduction........................................................................................................................................2 Scope...............................................................................................................................................................2 Overview.............................................................................
PAGE 3
Field Installation Procedure TOOLS REQUIRED #2 Phillips screwdriver Medium sized flat tip screwdriver(Magnetic recommended) T10-T20 Torx driver NMD50 Handle Conversion PARTS SUPPLIED PART NUMBERS DESCRIPTION QUANTITY 06100-00327 RL23xx/RL53xx NMD50 Field Replacement Handle Kit 1 02054-00194 Screw/M4 X 0.
PAGE 4
NMD Handle Conversion 2. Attach the door hinge side handle (below left) to the NMD50 using five (5) fasteners provided. Start all fasteners and tighten the lower middle fastener last. Above Left: Hinge Side Handle. Above Right: Lock Side Handle 4 3. Use same process for lock side handle, making certain all five (5) fasteners are tightened and that the lower middle fastener is tightened last. There is no variation in left and right side installation procedure.