manual

Triton Systems ©
62
 
e electronic lock has a Wrong Try Penalty lockout feature to prevent unauthorized personnel from accessing
cabinet. is feature performs as follows:
— Entry of four consecutive invalid combinations will start a 5-minute delay period. LED ashes red
at ten-second intervals during delay period.
— At the end of the 5-minute delay period, two more consecutive invalid combinations will begin
another 5-minute delay period.
— Lock will continue to produce 5-minute delays until combination is entered correctly.
 
(if manager code, time delay override, or remote override are programmed)
**Note**
Aer each key press, the lock will beep. Aer the nal digit is entered, the lock will beep twice. A triple beep
signals an invalid entry. Always perform this operation with the door open. If a mistake is made, wait 30 sec-
onds, then repeat steps.
1. Enter manager code and hold down last digit of code until the lock emits two sets of double beeps.
2. Press 1. Lock should beep twice.
— lock beeps once if a user code is already installed/programmed
— lock beeps twice if function was successful
— lock beeps three times if function was unsuccessful
3. Enter user code twice. e lock will beep twice aer each valid entry of the code.
 
(manager feature only)
**Note**
Aer each key press, the lock will beep. Aer the nal digit is entered, the lock will beep twice. A triple beep
signals an invalid entry. Always perform this operation with the door open. If a mistake is made, wait 30 sec-
onds, then repeat steps.
1. Enter manager code and hold down last digit of code until the lock emits two sets of double beeps.
2. Press 2. Lock should beep once. User is now temporarily disabled.
— lock beeps once if a user code is already installed/programmed
— lock beeps twice if function was successful
— lock beeps three times if function was unsuccessful
 
(manager feature only)
**Note**
Aer each key press, the lock will beep. Aer the nal digit is entered, the lock will beep twice. A triple beep
signals an invalid entry. Always perform this operation with the door open. If a mistake is made, wait 30 sec-
onds, then repeat steps.
1. Enter manager code and hold down last digit of code until the lock emits two sets of double beeps.
2. Press 1. Lock should beep once. User is now reinstated.
— lock beeps once if a user code is already installed/programmed
— lock beeps twice if function was successful
— lock beeps three times if function was unsuccessful