Guide

Ft7000 Controller PC Hard drive remove and rePlaCement ProCedures

INTRODUCTION

This guide details the steps to safely remove and replace the Hard Drive as a separate, internal com-

ponent of the FT7000 Controller PC Assembly. It includes the necessary steps to remove and replace

the Controller PC from the FT7000 terminal.

TOOLS REQUIRED

• FT7000 User Manual and Service Manuals

• Anti-static wrist strap

• USB Thumb Drive

• Small cross point screw driver

• Number 1 or 2 cross point screw driver

• Smallattipscrewdriver

• Key for the security lock of the terminal

• New FT7000 Hard Drive

Thefollowingproceduresmustbeperformedbyaqualied(trained)technician.

SAFETY

Observe all standard safety practices, as they apply to High Voltage and Electrostatic discharge.

PRELIMINARY REQUIREMENTS

1. Press Cntrl + 1 on the RSP keyboard and log into Management Functions.

2.InstallaUSBexternalstoragedevice(i.e.thumbdrive)intooneoftheControllerPC’sUSBports.

3. Select Option 8, Terminal Status.

4. Select Option 1, Display Conguration Summary. Save the summary to the USB storage de-

vice.

5. Select Option 2, Save Parameters to External Storage. Save the parameters to the USB storage

device.

6. Select Option 5, System Parameters.

7. Select Option 3, Shutdown Terminal.

8. Select Option 1 to answer Yes, Shutdown Terminal.

9. Switch off the Power Supply.

**IMPORTANT**

Prior to performing the remove and replace procedures, it is imperative that the

technician use a USB thumb drive to copy the configuration Parameter les of the

terminal. Failure to do so will require extensive re-conguration of the terminal

upon completion of the Hard Drive Replacement.