Owner Manual

2-4
EJ TO SECURITY MODULE UPGRADE PROCEDURES
9. Route the security module power and
communication cables up over the security
module as shown.
8. Obtain the Security Module Flat Bracket.
Insert the two posts on the bracket into the
two notches on the security module. Gently
push the security module towards the two
posts, fl exing the plastic ends slightly on both
sides, to insert the single post on the bracket
into the single notch on the module. Ensure
the security module is sitting fl ush against the
fl at bracket.
10. Attach a quick release cable clip to the bracket
with one nut as shown. Route the cables
through the clip. TY Wrap the cables together
as shown and cut off excess TY Wrap.