Owner Manual

2-3

FT5000

FT5000 UPGRADE

7. Connect the security module power cable and

communications cable to the new security

module as shown.

BEFORE PROCEEDING:

• Ensure all of your Journal Records have been saved to a USB ﬂ ash drive.

• Perform a proper management function shut down to remove power from the ATM.

• Unlock and open the ATM control panel. Turn the power switch to the OFF (0) position. If possible,

unplug the ATM power cord at the wall outlet.

• Open the dispenser area.

1. Disconnect the communication and power cables from your dispenser.

2. Refer to the applicable service manual for your unit to remove your dispenser. Removal of the dispenser

will provide the working room necessary to accomplish the upgrade.

3. Disconnect the dispenser to EJ cable and remove the cable from the split loom. Discard cable.

4. Disconnect the EJ to docking board or mainboard cable as applicable and remove the cable from the

split loom. Discard cable.

5. Remove the hardware attaching the EJ to the roof of the cabinet and remove the EJ. Discard.

Removal

Installation

6. Connect the new dispenser communication cable to the new security module. Tighten the thumbscrews to

secure the cable.

Communication

Power