Owner Manual

1B-29
RL5000
23. In the upper cabinet, route the security module
communication cable up through all four
previously loosened wire plate cable clips and
plug the cable into the docking/mainboard in
the “dispenser” jack. Tighten the wire plate
cable clips to secure the control panel cables.
24. Route the security module communication and
security module power cable around the unit’s
main power cable and over the power supply
(red arrows). Plug the power cable into the
power supply.
Ensure all excess security module power and
communication cable is pulled into the upper
cabinet. Loop the security module power cable
back on itself to condense the length of the cable.
TY Wrap the cable and cut off the excess. TY
Wrap the cables on the side of the power supply
and cut off excess (green arrows).
25. To complete the security module install, perform “Synchronizing the Security Module to the
Mainboard” on page 3.