Owner Manual

1B-24
EJ TO SECURITY MODULE UPGRADE PROCEDURES
9. Attach four quick release cable clips to the
mounting bracket using four 8/32 Hex Nuts.
Ensure the orientation of the clips matches the
picture as shown. Route the cables through the
middle cable clip.
8. Obtain the Security Module Flat Bracket.
Insert the two posts on the bracket into the
two notches on the security module. Gently
push the security module towards the two
posts, fl exing the plastic ends slightly on both
sides, to insert the single post on the bracket
into the single notch on the module. Ensure
the security module is sitting fl ush against the
fl at bracket.
Vault # 03015-00064 / 03015-00200 / 03015-00227 with an NMD 50 Dispenser
Back Wall Mounting
10. Route the security module power cable and the
security module communication cable through
the left lower cable clip as shown.