Owner Manual

1B-23
RL5000
23. In the upper cabinet, route the security module
communication cable up through all four
previously loosened wire plate cable clips and
plug the cable into the docking/mainboard in
the “dispenser” jack. Tighten the wire plate
cable clips to secure the control panel cables.
24. Route the security module communication
and security module power cable around
the unit’s main power cable and over the
power supply (red arrows). Plug the power
cable into the power supply.
Ensure all excess security module power
and communication cable is pulled into the
upper cabinet. Loop the security module
power cable back on itself to condense the
length of the cable. TY Wrap the cable and
cut off the excess. TY Wrap the cables on
the side of the power supply and cut off
excess (green arrows).
25. To complete the security module install, perform “Synchronizing the Security Module to the
Mainboard” on page 3.