Owner Manual

1B-10
EJ TO SECURITY MODULE UPGRADE PROCEDURES
20. Route the Dispenser data cable from the
security module assembly through the two
cable clips on the right side of the NMD50
dispenser as shown.
(Dispenser removed from the unit for clarifi cation)
21. Route the Dispenser data cable across the top
of the dispenser, through the cable clip on the
left side of the dispenser and plug it into the
dispenser as shown.
(Dispenser removed from the unit for clarifi cation)
Unlock the slides and push the dispenser into
the cabinet.
22. In the upper cabinet, route the security module
communication cable up through all four
previously loosened wire plate cable clips and
plug the cable into the docking/mainboard in
the “dispenser” jack. Tighten the wire plate
cable clips to secure the control panel cables.