Owner Manual

1A-25
RL5000
17. Loop the security module power cable
back on itself to condense the length of the
cable. TY Wrap the cable and cut off the
excess.
16. In the upper cabinet, route the security module
communication and security module power
cable around the unit’s main power cable and
over the power supply. Plug the power cable
into the power supply. Route the security
module cable up through all four previously
loosened wire plate cable clips and plug
the cable into the docking/mainboard in the
“dispenser” jack. Tighten the wire plate cable
clips to secure the control panel cables.
18. To complete the security module install, perform “Synchronizing the Security Module to the
Mainboard” on page 3.