Owner Manual

1A-24
EJ TO SECURITY MODULE UPGRADE PROCEDURES
13. Obtain the dispenser power cable. Plug the
power cable into the unit’s power supply in the
upper portion of the cabinet. Route the cable
through the left hole opening into the lower
cabinet.
15. Ensure all extra security module communication
cable and security module power cable is
pulled into the upper cabinet. TY Wrap all the
cables together as shown and cut off excess TY
Wrap. Route the cables under the bracket as
shown.
14. Plug the cables into the back of the SDD
dispenser and tighten the thumbscrews on the
communication cable to secure it. Reinstall
the dispenser into the unit.