Owner Manual

1A-20
EJ TO SECURITY MODULE UPGRADE PROCEDURES
14. Obtain the dispenser power cable. Plug the
power cable into the unit’s power supply in
the upper portion of the cabinet. Route the
cable through the anti-fi shing bracket and the
left hole opening into the vault. Route the
dispenser power cable through the rear left
cable clip as shown.
Reinstall the two washers and two bolts to secure
the anti-fi shing bracket.
15. Loop the SDD communication cable back on
itself twice to condense the length of the cable
to match the length of the dispenser power
cable. TY Wrap the two cables together in two
spots as shown. Cut off the excess TY Wraps.
16. Plug the cables into the back of the SDD and
tighten the thumbscrews on the communication
cable to secure it. Reinstall the dispenser into
the unit.