Owner Manual

1A-8
EJ TO SECURITY MODULE UPGRADE PROCEDURES
14. Loop the SDD dispenser communication cable
back on itself twice to condense the length of
the cable to match the length of the dispenser
power cable. TY Wrap the two cables together
in two spots as shown. Cut off the excess TY
Wraps.
15. Plug the cables into the back of the SDD
dispenser and tighten the thumbscrews on the
communication cable to secure it. Reinstall
the dispenser into the unit.
16. In the upper cabinet, route the security module
communication cable up through all four
previously loosened wire plate cable clips and
plug the cable into the docking/mainboard in
the “dispenser” jack. Tighten the wire plate
cable clips to secure the control panel cables.