Owner Manual

1A-6
EJ TO SECURITY MODULE UPGRADE PROCEDURES
9. Attach four quick release cable clips to the
mounting bracket using four 8/32 Hex Nuts.
Ensure the orientation of the clips matches the
picture as shown. Route the cables through the
middle cable clip.
10. Route the dispenser communication cable
through the left clip (blue arrow). Route the
security module power cable and security
module communication cable through the right
clip (red arrow).
Cabinet # 09700-00000 with an SDD Dispenser
Right Side Mounting
8. Obtain the Security Module Flat Bracket.
Insert the two posts on the bracket into the
two notches on the security module. Gently
push the security module towards the two
posts, fl exing the plastic ends slightly on both
sides, to insert the single post on the bracket
into the single notch on the module. Ensure
the security module is sitting fl ush against the
fl at bracket.