Installation instructions

FIELD REPLACEMENT PROCEDURE

REPLACING THE CCFL BACKLIGHTS WITH THE LED

BACKLIGHTS IN AN APOLLO DISPLAY

To replace the CCFL backlights with the LED backlights, complete the following procedure:

1. Put the ESD wrist strap on and attach the cord to ground. Wear the safety glasses during the replacement

process.

2. Obtain the display previously set aside.

3. Locate where the backlight rails enter the display (on the right side of the display). BEFORE pulling the

backlight rail out, locate the locking latch shown below. While holding the locking latch up, gently pull the

CCFL backlight rail out.

4. Repeat step 3 for the second CCFL backlight rail.

5. Using the small pliers, bend up the rail tab covering the bulbs.

6. Peel the tape covering the rail tab off. Cut the black wire as close to the rail tab as possible.

Apollo Display Triton Part Numbers

01160-00023 Display only

09200-00010 Assembly

09200-00091 Assembly

09200-00208 Assembly

Tools:

1 - ESD wrist strap with grounding cord

1 - Safety glasses

1 - Small wire cutters

1 - Small needle nose pliers