Owner Manual

7
BALLAST/BULB TO LED CONVERSION (FT5000)
Units that have power supplies where all 8-pin connectors are in use:
Remove one (1) of the cables (preferably any that has two (2) wires connected)
from the power supply. Using the power splitter cable included (P/N 09120-
00826), connect the LED power cable to one side and the recently removed
cable to the other. Plug the female end of the splitter to an 8-pin molex
connector on the power supply.
3. Using the ty-wraps provided, secure the LED power cable with the other
bundled cables.
4. Rotate the printer assembly up to the operate position. Turn the power
supply switch to the ON position.
power splitter cable