Owner Manual

BALLAST/BULB TO LED CONVERSION (FT5000)

2. Install the LED light panel assembly as shown below with the three (3)

screws removed from the previous step.

ÂÂ

Â CABLE ROUTING AND CONNECTIVITY:

1. Route the LED power cable (and speaker wires) through the slot shown

below. If a grommet was previously in place, route cables through the

grommet and insert grommet in the slot.

2. Connect the 8-pin molex connector of the LED power cable to any unused

connector of the power supply. Note: The largest connector (10-pin) of

the power supply is reserved. DO NOT connect the LED power cable here!