Owner Manual

5
BALLAST/BULB TO LED CONVERSION (FT5000)
ÂÂ
ÂÂ
 ASSEMBLE LED LIGHT BAR/BRACKET/CABLE:
1. Mount the LED light bar (P/N 09100-00188) to the bracket (P/N 03011-00789)
as shown in figure below. Secure with the three (3) screws/nuts provided
using a phillips screwdriver and box wrench.
2. Plug the 2-pin connector end of the LED power cable (P/N 09120-00332) to
J5 on the LED light bar module as shown below.
ÂÂ
ÂÂ
 INSTALL LED LIGHT PANEL A SSEMBLY:
1. Using a phillips screwdriver (magnetic recommended), remove the three (3)
screws shown and set aside. Note: The two (2) lower screws also secure
small brackets. These brackets will not be required for the new LED light
panel.