Owner Manual

ManualsBrandsTriton Systems ManualsOtherFT5000 Xscale Series

Zoom modem

XScale InStallatIon ProcedureS

TDN 07103-00329

April 8, 2011

registered trademark of Triton Systems of Delaware LLC.

corPorate HeadquarterS:

21405 B St.

Long Beach, MS 39560

Phone: (800) 259-6672

Fax: (228) 868-9445

Summary of content (4 pages)

PAGE 1
Zoom Modem XScale Installation Procedures TDN 07103-00329 April 8, 2011 Corporate Headquarters: 21405 B St. Long Beach, MS 39560 Phone: (800) 259-6672 Fax: (228) 868-9445 COPYRIGHT NOTICE © 2011 Triton. All Rights Reserved. TRITON logo is a registered trademark of Triton Systems of Delaware LLC.
PAGE 2
Zoom Modem XScale Installation DOCUMENT UPDATES April 8, 2011 Original This procedure describes the steps necessary to replace the existing phone modem with the Triton Zoom PCMCIA modem in XScale (X1) ATMs. A software update file is required. Software Requirement The zip file name is: XScale Modem Update.exe Software can be obtained from the Triton partner web site. • Download the .exe to your PC • Double click on the .exe, it will self extract • Read the release notes • Load the .
PAGE 3
Modem Installation NOTE: Go to the Triton Partner web site and download the file mentioned on page two (2). This file is not large and will allow the ATM to recognize the modem upon startup. After the file is loaded, proceed with the modem installation. 1. Power down the ATM (Management Functions > System Parameters > Shut Down) Open the upper cabinet. 2. Disconnect the telephone input line from the existing telephone modem. Remove the PCMCIA Modem card or USB modem from the ATM. 3.
PAGE 4
Zoom Modem XScale Installation 4. Attach the Zoom cable to the Zoom Modem, the RJ45 coupler to the end of the Zoom Cable, and insert the existing telephone cable from the wall into the coupler. Note the cable clips are opposite. 5. Route the excess cable inside the cabinet so as not to be pinched or cut. Allow enough slack and movement to facilitate the opening of the upper fascia. Secure the excess cable as necessary. 6. Start the ATM and close the upper fascia. The POST should find the new modem.