Guide

4.34 Automated Teller Machines.
4.34.1 General. Each automated teller machine required to be accessible by 4.1.3 shall be on an accessible route
and shall comply with 4.34.
4.34.2 Clear Floor Space. e automated teller machine shall be located so that clear oor space complying with
4.2.4 is provided to allow a person using a wheelchair to make a forward approach, a parallel approach, or both,
to the machine.
4.34.3 Reach Ranges.
(1) Forward Approach Only. If only a forward approach is possible, operable parts of all controls shall be
placed within the forward reach range specied in 4.2.5.
(2) Parallel Approach Only. If only a parallel approach is possible, operable parts of controls shall be
placed as follows:
(a) Reach Depth Not More an 10 in (255 mm). Where the reach depth to the operable parts of all
controls as measured from the vertical plane perpendicular to the edge of the unobstructed clear oor
space at the farthest protrusion of the automated teller machine or surround is not more than 10 in
(255 mm), the maximum height above the nished oor or grade shall be 54 in (1370 mm).
(b) Reach Depth More an 10 in (255 mm). Where the reach depth to the operable parts of any
control as measured from the vertical plane perpendicular to the edge of the unobstructed clear oor
space at the farthest protrusion of the automated teller machine or surround is more than 10 in
(255 mm), the maximum height above the nished oor or grade shall be as follows:
Reach Depth Maximum Height
10 in. 255 mm 54 in. 1370 mm
11 in. 280 mm 53.5 in. 1360 mm
12 in. 305 mm 53 in. 1345 mm
13 in. 330 mm 52.5 in. 1335 mm
14 in. 355 mm 51.5 in. 1310 mm
15 in. 380 mm 51 in. 1295 mm
16 in. 405 mm 50.5 in. 1285 mm
17 in. 430 mm 50 in. 1270 mm
18 in. 455 mm 49.5 in. 1255 mm
19 in. 485 mm 49 in. 1245 mm
20 in. 510 mm 48.5 in. 1230 mm
21 in. 535 mm 47.5 in. 1205 mm
22 in. 560 mm 47 in. 1195 mm
23 in. 585 mm 46.5 in. 1180 mm
24 in. 610 mm 46 in. 1170 mm
(3) Forward and Parallel Approach. If both a forward and parallel approach are possible, operable
parts of controls shall be placed within at least one of the reach ranges in paragraph (1) or (2) of this