manual

Diagnostics
49
6. enable Dncp (DynaMic host configuration protocol)- This is a protocol that provides a means to
dynamically allocate IP Addresses to computers on a LAN system.
B Press the <6> key on the keypad to enable (checked) or disable (unchecked).
7. local ports- These options allow entering Incoming and/or Outgoing local port addresses.
Incoming: Change the Incoming Port address by pressing <7> on the keypad. Enter the new port
address in the data entry dialog box. Press <enter>.
Outgoing: Change the Outgoing Port address by pressing <8> on the keypad. Enter the new port
address in the data entry dialog box. Press <enter>.
MoDeM setup string
access instructions:
From the Diagnostics screen, select the Modem/Ethernet option by pressing the <7> on the keypad.
From the Modem/Ethernet screen, select the Modem Setup String
NOTE: Incoming and Outgoing
Ports CANNOT be the same!
Description:
The Modem Setup String is used in special
circumstances. A Hayes-compatibile setup string can
be sent to the modem when it is initialized.
note: If needed, setting this value will cause
communication failure. Contact Triton Technical
Support service before entering/changing this
parameter.