manual

46
X2 configuration Manual
This screen will allow you to view and congure the following modem properties from the Port Settings tab:
1. bits per seconD- Baud rate setting for the terminal’s modem.
2. Data bits- Number of data bits.
3. parity- Parity type: even or odd.
4. stop bits- Number of stop bits.
5. floW control- Choose the type of ow control to use if required. In most cases the default setting for
the parameters in the congure dialog will satisfy your modem communication requirements. However
in some cases, changes may be required to meet unique requirements. Usually these will be determined
by the processor and congured by your service provider.
Once the necessary parameters have been selected, press the <clear> key until the Port Settings tab is
highlighted. Press the right arrow (>) key to display the parameters for the Call Options. Use the <clear>
key to highlight the parameter that will be congured.
If the parameter is enabled by placing a check in a box, highlight the parameter and press the <ctrl>
key to place or remove a check from the box. If the parameter is a numeric value, press the <clear> key
until the entry area is highlighted. Enter the number directly from the keypad. If the entry is a letter of the
alphabet, open the virtual keypad and use it to enter the letter(s).